Readers

SW-R-301 Card Reader is a model with traditional design in the universal proximity cardreader series SW-R-x01. Coloured anthracite or beige, it is a normal RFID reader in an ABSplastic casing with dull finish available for either indoor or outdoor use. PIN-code versionsare not available. It allows for a wide range of 13.56 MHz card technologies, whileidentification implements with an operating frequency of 125 kHz are not supported atpresent. Interface formats available include standard AbaTrack2, Wiegand, TTL serial, andCAN bus. In lack of enough space, versions with CAN bus cannot be added an I/O module. Itcan be mounted on metal surfaces via the spacers and brackets supplied, which makes itavailable for use at vehicular access control points too.

SW-R-401 Card Reader is the most commonly installed model in the universal proximity cardreader series SW-R-x01. It is available either as a normal RFID reader or along with an addedPIN keypad in a black-coloured ABS plastic casing with dull finish. It allows for a wide rangeof 13.56 MHz card technologies. Alternatively, with an add-on module built in, it can beturned into a dual reader to accommodate 125 kHz Indala cards as well. Interface formatsavailable include standard AbaTrack2, Wiegand, TTL serial, RS-232, CAN bus, and USB.Versions with CAN bus can be added an I/O module to run an access control point withoutneed for an SC-1000 access control module. It can be mounted on metal surfaces via thespacers and brackets supplied, which offers use at vehicular access control points, orattached a card-pocket for use in card-present mode.

SW-R-501 is the smallest-size model in the universal proximity card reader series SW-R-x01.It is offered as a normal RFID reader designed for indoor use only in a black-coloured ABSplastic casing with dull finish, and PIN-code versions are not available. It allows for a widerange of 13.56 MHz card technologies, not supporting identification implements with anoperating frequency of 125 kHz at present. Interface formats available include standardAbaTrack2, Wiegand, TTL serial, and CAN bus.

The GP90 type of proximity readers recommended to use at such installation where bigger reader distance needed and high security cards are not required. The reader transmit frequency is 125 kHz and belongs to the so called „non-conversational” system category, which means the communication between the reader and identification not encrypted. The reader works with the  ASK type of EM4001 card and with the 64-bit Manchester encoded or compatible cards.

It has an automatic tuning feature that helps to minimize the negative reading-distortion effects of metal and other sources of noise in the reader's ambient.

Ideally, the reading distance may reach 90 cm, but in practice, a lower value is acceptable. In order to avoid faulty reading between two readers, a distance of three times the reading distance must be maintained.

The device has Magstripe AbaTrack2, Wiegand, RS-232 and RS-485 interfaces, allowing for extensive use. In Seawing system the AbaTrack2 interface is preferred.

The reader comes in black colour with a matte plastic cover, without power supply. It can also be fitted with a mounting column that facilitates the installation of the vehicle entry points.